Skip to main content

Week 1

During Week 1 of our Design Project, the group was introduced to our end goal, and what kind of device we would focus on creating. We also took time to form our group, and begin drafting up some ideas that we could build future designs off of. In creating our ideas, some areas that we focused on were human mobility, posture improvement, and sleep aids.

In the Week 1 Brainstorming tab, you can follow our brainstorming progress and thought-process!

Comments

Post a Comment

Popular posts from this blog

Week 4

During the fourth week of our Design Project, the team worked on sourcing and gathering all of the materials that we would need for the project. This included cardboard, hinges, servo motors, wiring, and an arduino board. The weekly lab period was used for creating the basic design concept of the device in AutoCAD, and starting the coding for the arduino board. For our first prototype, we plan on constructing the body out of thick cardboard, which will allow us to make quick adjustments and changes without the use of much hardware.   Figure 1: Front View Figure 2: Back View
Post a Comment
Read more

Week 9

During Week 9, we assembled the final parts of the pill dispenser. The motors were placed inside of the motor compartment, and the pill dispensing compartments were created. We plugged in each motor and tested the dropping mechanism using our Arduino code. Each slot was successfully able to dispense the pill capsule onto the ramp below. Included are pictures of our wiring and prototype so far.
Post a Comment
Read more

Week 10

Week 10 was the final week of our Design Project. During this week, finishing touches were added to the pill dispenser, including optimization of the code, and the locking mechanism as a fail-safe. The group also had a chance to present their project both in class, and at the senior design event, where ten freshman design groups were also allowed to present their project.
Post a Comment
Read more